Dukane 8806 用户手册
25
OFF
VIDEO
S-VIDEO
VIEWER
LAN
COMPUTER
COMPONENT
ON
POWER
POWER
MENU
EN
TER
EX
IT
3
1
2
SELECT
3. Projecting an Image (Basic Operation)
Note on Startup screen (Menu Language Select screen)
When you first turn on the projector, you will get the Startup menu. This menu gives you the opportunity to select one
of the 21 menu languages.
of the 21 menu languages.
To select a menu language, follow these steps:
1. Use the SELECT
button to select one of the 21 lan-
guages for the menu.
2. Press the ENTER button to execute the selection.
NOTE:
• The projector cannot be turned off for 60 seconds after the lamp is turned on and while the POWER indicator is blinking green.
• If you turn on the projector immediately after the lamp is turned off or when the ambient temperature is high, the cooling fans will
• The projector cannot be turned off for 60 seconds after the lamp is turned on and while the POWER indicator is blinking green.
• If you turn on the projector immediately after the lamp is turned off or when the ambient temperature is high, the cooling fans will
run for a moment and then you will get an image on the screen.
• Immediately after turning on the projector, screen flicker may occur. This is normal. Wait 3 to 5 minutes until the lamp lighting is
stabilized.
•
When the Lamp mode is set to Eco, the Lamp indicator will light green.
•
If one of the following things happens, the projector will not turn on.
-
If the internal temperature of the projector is too high, the projector detects abnormal high temperature. In this
condition the projector will not turn on to protect the internal system. If this happens, wait for the projector's
internal components to cool down.
condition the projector will not turn on to protect the internal system. If this happens, wait for the projector's
internal components to cool down.
-
When the lamp reaches its end of usable life, the projector will not turn on. If this happens, replace the lamp.
(→ page
(→ page
110
)
-
If the lamp fails to light, and if the STATUS indicator flashes on and off in a cycle of six times, wait a full minute
and then turn on the power.
and then turn on the power.
OFF
VIDEO
S-VIDEO
VIEWER
LAN
COMPUTER
COMPONENT
ON
SELECT
POWER
POWER
3
1
2
MENU
EN
TER
EX
IT
OFF
VIDEO
S-VIDEO
VIEWER
LAN
COMPUTER
COMPONENT
ON
SELECT
POWER
POWER
MENU
3
1
2
EN
TER
EX
IT
3. To close the menu, press the EXIT button.
After this has been done, you can proceed to the menu op-
eration.
If you want, you can select the menu language later. (→ [Lan-
guage] on page
eration.
If you want, you can select the menu language later. (→ [Lan-
guage] on page
81
)
SOURCE
AUTO ADJUST
3D REFORM
SELECT
SOURCE
AUTO ADJUST
3D REFORM
SELECT
SOURCE
AUTO ADJUST
3D REFORM
SELECT