Planar PD7170 用户手册

PREL

IMINA

RY

)  

Press to select a highlighted menu item or confirm a changed setting. 

 

When no menu is present on-screen, press ENTER to access the motorized lens 

focus control. Press ENTER again to access the motorized lens zoom control. 

Press ENTER yet again to access the motorized lens shift control.  

 

Use the   and   buttons to adjust focus, zoom or vertical lens position. Use 

the   and   buttons to adjust horizontal lens position. 

 

MENU 

Press this button to show or hide the OSD menus. 

• POWER BUTTON/STATUS LED 

Indicates projector status as follows:
• Solid green = AC power present, ready to turn on (lamp not lit)
• Flashing green = lamp is warming up or cooling down; keypad functions 

not allowed

• Off = Lamp lit, projector functioning normally
• Alternating green/red = Lamp problem (door open, unable to strike, end 

of life), user intervention likely to fix problem

• Flashing red = Over temperature, user intervention (clear vents, turn on AC) 

may fix problem

• Solid red = Error that requires servicing (fan fail, Power-on self-test fail etc.)

• EXHAUST VENT 

Warm air exits the projector through this vent. Ensure that it is not blocked. 

• INTAKE VENT 

Internal fans draw cool air into the projector through this vent. 

• PROJECTION LENS 

The inside of the lens barrel is threaded to accommodate a standard, 72-mm 

lens filter. For example, with a smaller screen you can install a neutral-density 

filter to reduce the overall light output.  

 

If needed, a light shield accessory is provided with the lens to minimize stray 

light emissions. (Use it only when the vertical offset is 50% of the screen height 

or greater.) The light shield attaches to the end of the lens (or to the filter, if 

used). 

• FRONT IR SENSOR 

Receives infrared signals from the remote control unit.