Optoma Technology TW675UST3D 用户指南

3

English

 

 

Warning-  Do not look into the projector’s lens when the lamp is 

on. The bright light may hurt and damage your eyes.

 

Warning-  To reduce the risk of fire or electric shock, do not 

expose this projector to rain or moisture.

 

Warning-  Please do not open or disassemble the projector as 

this may cause electric shock.

 

Warning-  When replacing the lamp, please allow the unit to 

cool down. Follow instructions as described on pages 

76-77.

 

Warning-  This projector will detect the life of the lamp itself. 

Please be sure to change the lamp when it shows 

warning messages.

 

Warning-  Reset the “Lamp Reset” function from the on-screen 

display “OPTIONS | Lamp Settings” menu after 

replacing the lamp module (refer to page 53).

 

Warning-  When switching the projector off, please ensure 

the cooling cycle has been completed before 

disconnecting power. Allow 90 seconds for the 

projector to cool down.

 

Warning-  Do not use lens cap when projector is in operation.

 

Warning-  When the lamp is approaching the end of its lifetime, 

the message “Lamp Warning: Lamp life exceeded.” 

will show on the screen. Please contact your local 

reseller or service center to change the lamp as soon 

as possible.

 

Warning-  Do not look into or point the laser pointer on your 

remote control into your or someone’s eyes. Laser 

pointer can cause permanent damage to eyesight. 



When the lamp 

reaches the end 

of its life, the pro-

jector will not turn 

back on until the 

lamp module has 

been replaced. 

To replace the 

lamp, follow the 

procedures listed 

under “Replacing 

the Lamp” section 

on pages 76-77.