Optoma Technology HD82 用户手册

English

 

When the lamp reaches 

the end of its life, the 

projector will not turn 

back on until the lamp 

module has been 

replaced. To replace 

the lamp, follow the 

procedures listed under 

“Replacing the Lamp” 

section on page 42.

■ 

Warning-

Do not look into the projector’s lens when the 

lamp is on.  The bright light may hurt your 

eyes.

■ 

Warning-

To reduce the risk of fire or electric shock, do 

not expose this projector to rain or moisture.

■ 

Warning-

Please do not open or disassemble the projec-

tor as this may cause electric shock.

■ 

Warning-

When replacing the lamp, please allow the 

unit to cool down.  Follow instructions as 

described on page 42.

■ 

Warning-

This projector will detect the life of the lamp it-

self.  Please be sure to change the lamp when 

it shows warning messages.

■ 

Warning-

Reset the “Lamp Reset” function from the on-

screen display “System|Lamp Setting” menu 

after replacing the lamp module (refer to page 

34).

■ 

Warning-

When switching the projector off, please 

ensure the cooling cycle has been completed 

before disconnecting power. Allow 90 seconds 

for the projector to cool down.

■ 

Warning-

Do not use lens cap when projector is in 

operation.

■ 

Warning-

When the lamp is approaching to the end of its 

life time, the message “Replacement suggest-

ed” will show on the screen. Please contact 

your local reseller or service center to change 

the lamp as soon as possible.

N

ote

N

ote