Philips PT-LB10VU 用户手册

 

 

03/28/05 

SP Controls reserves the right to modify specifications without notice at any time.

 

 
NOTE: This one-page document is intended only as a quick reference for installation – please read 
the SP Controls Application Note for a complete description of this projector driver prior to installation. 

 1. Input Selection Mapping 

Selection 1:  VIDEO 
Selection 2:  S-VIDEO 
Selection 3:  RGB 
Selection 4:  NETWORK 

 
 2. Hidden Function Mapping (Default Configuration) 
Using the ON button as a shift key, press the following buttons to access the specified projector features. 

Selection 1:  AV MUTE 
Selection 2:  ENTER 
Selection 3:  ADJUST LEFT 
Selection 4:  ADJUST RIGHT 

Off:  MENU  

Volume Up:  ADJUST UP 

Volume Down:  ADJUST DOWN 

Power Status Feedback Method  RS-232 Power Polling   

Control Wiring:  RS-232 and IR-Emitter  

 
NOTE: The Panasonic PT-LB10VU projector serial port is a female 8-pin mini-DIN. This document 
provides instructions for terminating the RS-232 control cable directly onto an 8-pin mini-DIN connector. If 
you wish to terminate the control cable on a standard DB9 connector, an adaptor cable may be 
separately ordered from Panasonic (Panasonic part no. ET-ADSER).  
 
1. RS-232:  
    Wire the Panel RS-232 port to a male 8-pin mini-DIN as follows: 

RX to  5 

TX to  3 

GND to  4 

     Connect this male DB9 to the projector port labeled SERIAL.  
 
2. Infrared Emitter:  
     Wire the Panel IR/Serial port to a female 1/8" Mini as follows: 

IR/SER to  tip 

GND to  ring 

     Connect to the included IR Emitter and attach the emitter bud to any projector IR window.