Panasonic PTAE7000U 用户手册

ENGLISH

 - 97

The serial port on the connector panel of the projector conforms to the RS-232C interface specification, so the 

projector can be controlled by a personal computer connected to this port.

■

Serial terminal (female)

D-sub 9 pin (male)

Computer

■

 

 

(6)

(1)

(9)

(5)

(1)

—

NC

(2)

TXD

Transmitted data

(3)

RXD

Received data

(4)

—

NC

(5)

GND

Earth

(6)

—

NC

(7)

RTS

Connected internally

(8)

CTS

(9)

—

NC

■

Signal level

RS-232C

Character length

8 bits

Sync. method

Asynchronous

Stop bit

1 bit

Baud rate

9 600 bps

X parameter

None

Parity

None

S parameter

None

■

STX

Command

:

Parameter

ETX

Start byte 

(02h)

1 byte

End 

(03h)

3 bytes

1 byte - 4 bytes

Data streaming from the computer will start with STX, 

and proceed to command, parameter and end with 

ETX.

Parameters can be added as necessary.

The projector cannot receive any command for 10 seconds after the lamp is switched on. Wait 10 seconds before sending 

 

z

a command.

If sending multiple commands, check that a response has been received from the projector for one command before 

 

z

sending the next.

When a command which does not require parameters to be sent, a colon (:) is not required.

 

z

If an incorrect command is sent, the ER401 command will be sent from the projector to the personal computer.

 

z