Texas Instruments TMS320DM357 用户手册
3.2.1.4
IN Status Phase (following SETUP Phase or OUT Data Phase)
IN token sent
?
received
STALL
No
Yes
Yes
No
RxStall set
ReqPkt cleared
Error Count cleared
Interrupt generated
Yes
?
Data1
received
Transaction
complete
No
NAK
received
?
Yes
?
NAK limit
reached
No
Yes
Error count
cleared
incremented
Error count
NAK Timeout set
Endpoint halted
Interrupt generated
?
Error
count=3
No
Error bit set
ReqPkt cleared
Error Count cleared
Interrupt generated
Yes
Implies problem
at peripheral end
of connection.
at peripheral end
of connection.
Transaction deemed
complete
Completion of either SETUP
phase or OUT data phase
No
ACK sent
RxPktRdy
set
ReqPkt cleared
Error Count cleared
Interrupt generated
ReqPkt
and StatusPkt
both set
?
Command could
not be completed
not be completed
www.ti.com
USB Controller Host and Peripheral Modes Operation
For the IN Status Phase of a Control Transaction (
), the software driving the USB Host device
needs to:
1. Set the STATUSPKT and REQPKT bits of HOST_CSR0 (bit 6 and bit 5, respectively).
2. Wait while the controller sends an IN token and receives a response from the USB peripheral device.
2. Wait while the controller sends an IN token and receives a response from the USB peripheral device.
Figure 12. Completion of SETUP or OUT Data Phase Flow Chart
SPRUGH3 – November 2008
Universal Serial Bus (USB) Controller
49