Transition Networks E-PSW-TX-02 用户手册
2. SITE CONSIDERATIONS
The site for the Transition Networks’ pocket switch must provide:
•
AC power outlet for each Transition Networks’ pocket switch
•
Adequate ventilation
•
Standard environmental conditions
•
Isolation from electrical noise, including radio transmitters and
broadband amplifiers, motors, high power electrical lines, or
fluorescent light fixtures.
broadband amplifiers, motors, high power electrical lines, or
fluorescent light fixtures.
Additionally:
•
The twisted pair cables should not run in the same conduit with
power line cables.
power line cables.
•
Phone lines should be separated from data cables.
•
Flat or “silver satin” wires should not be used.
And:
•
The entire installation should comply with the IEEE Ethernet
802.3 and the 802.3u specifications.
802.3 and the 802.3u specifications.
3. INSTALLATION
To install the Transition Networks’ pocket switch:
• Unpack Transition Networks’ pocket switch
• Install Transition Networks’ pocket switch on stable, flat
• Install Transition Networks’ pocket switch on stable, flat
surface
• Set DIP switch
• Install network cable
•
• Install network cable
•
Power Transition Networks’ pocket switch.
Direction is provided in the pages that follow.
Unpacking
the
Transition Networks’ Pocket Switch
The Transition Networks’ pocket switch packing contents should
include the following:
include the following:
Item
Part Number
Transition Networks’
E-PSW-TX-02
Pocket Switch
OR
E-PSW-FX-02
E-PSW-FX-02
Power Supply Adapter
3340, 3507, 3342, 3340, 3346, 3511,
OR 3537
OR 3537
/power cord: 3522
.
(depending upon power configuration
in country where installed)
in country where installed)
User’s Guide
33015
Installing on Flat, Stable Surface
The Transition Networks’ pocket switch was designed and built to be
installed on a table or shelf.
installed on a table or shelf.
Ensure that the installation location is:
•
stable
•
well- ventilated
•
near a standard AC electrical outlet.
Transition Networks’
Pocket Switch
14
13