Cabletron Systems 7F06-02 用户手册
INSTALLATION/REMOVAL
3-3
Notes:
The left most slot in the 7C03 MMAC SmartSwitch is reserved for
the 7X00 SmartSwitch Module.
the 7X00 SmartSwitch Module.
Before installing the 7F06-02 module, attach the wrist strap
included with the SmartSwitch or SmartSwitch module by
following the instructions printed on the package.
included with the SmartSwitch or SmartSwitch module by
following the instructions printed on the package.
1. Remove the blank panel covering the slot in which the module will be
installed. All other slots must remain covered to ensure proper airflow
and cooling.
and cooling.
Ensure that the printed circuit board (PCB) is between the card guides,
slides in straight, and engages the backplane connectors properly.
slides in straight, and engages the backplane connectors properly.
3. Using a slotted screwdriver, tighten the top and bottom screws.
Figure 3-2. Installing the 7F06-02 Module in the
7C03 MMAC SmartSwitch
3.3.2 Removing from the7C03 SmartSwitch
The 7F06-02 Module inserted in the 7C03 MMAC SmartSwitch can
be removed whenever necessary. Follow the steps below and refer
to Figure 3-3 to remove the module.
be removed whenever necessary. Follow the steps below and refer
to Figure 3-3 to remove the module.
CPU
SN
TPR
TPRMI
Card
Guides
Guides