IBM 12.1(22)EA6 用户手册

下载
页码 550
 
11-6
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter 11      Configuring Optional Spanning-Tree Features
Understanding Optional Spanning-Tree Features
to the root switch). Under spanning-tree rules, the switch ignores inferior BPDUs for the configured 
maximum aging time specified by the spanning-tree vlan vlan-id max-age global configuration 
command. 
The switch tries to determine if it has an alternate path to the root switch. If the inferior BPDU arrives 
on a blocked port, the root port and other blocked ports on the switch become alternate paths to the root 
switch. (Self-looped ports are not considered alternate paths to the root switch.) If the inferior BPDU 
arrives on the root port, all blocked ports become alternate paths to the root switch. If the inferior BPDU 
arrives on the root port and there are no blocked ports, the switch assumes that it has lost connectivity 
to the root switch, causes the maximum aging time on the root port to expire, and becomes the root 
switch according to normal spanning-tree rules.
If the switch has alternate paths to the root switch, it uses these alternate paths to send a root link query 
(RLQ) request. The switch sends the RLQ request on all alternate paths to the root switch and waits for 
an RLQ reply from other switches in the network. 
If the switch determines that it still has an alternate path to the root, it expires the maximum aging time 
on the port that received the inferior BPDU. If all the alternate paths to the root switch indicate that the 
switch has lost connectivity to the root switch, the switch expires the maximum aging time on the port 
that received the RLQ reply. If one or more alternate paths can still connect to the root switch, the switch 
makes all ports on which it received an inferior BPDU its designated ports and moves them from the 
blocking state (if they were in the blocking state), through the listening and learning states, and into the 
forwarding state.
 shows an example topology with no link failures. Switch A, the root switch, connects 
directly to Switch B over link L1 and to Switch C over link L2. The Layer 2 interface on Switch C that 
connects directly to Switch B is in the blocking state. 
Figure 11-5
BackboneFast Example Before Indirect Link Failure
If link L1 fails as shown in 
, Switch C cannot detect this failure because it is not connected 
directly to link L1. However, because Switch B is directly connected to the root switch over L1, it detects 
the failure, elects itself the root, and begins sending BPDUs to Switch C, identifying itself as the root. 
When Switch C receives the inferior BPDUs from Switch B, Switch C assumes that an indirect failure 
has occurred. At that point, BackboneFast allows the blocked port on Switch C to move immediately to 
the listening state without waiting for the maximum aging time for the port to expire. BackboneFast then 
transitions the Layer 2 interface on Switch C to the forwarding state, providing a path from Switch B to 
Switch A. This switchover takes approximately 30 seconds, twice the Forward Delay time if the default 
Forward Delay time of 15 seconds is set. 
 shows how BackboneFast reconfigures the 
topology to account for the failure of link L1.
L1
L2
L3
Switch C
Switch A
(Root)
Switch B
Blocked port
44963