Cabletron Systems 2E48-27R 用户手册
High Speed Interface Configuration Screen
2E48-27R/2E49-27R User’s Guide
5-53
Advertised Ability (Selectable)
During auto-negotiation, the FE-100TX informs the device at the other
end of the segment about its capabilities. The capabilities of a port (25 or
26) with an FE-100TX installed are 10BASE-T, 10BASE-TFD (full
duplex mode), 100BASE-TX and 100BASE-TXFD (full duplex mode).
In normal operation, with all capabilities enabled, the FE-100TX
“advertises” that it has the ability to operate in any mode. The Network
Manager may choose to set up the port so that only a portion of the
available capabilities are advertised and the others are disabled. For
example, only 100BASE-TX and 100BASE-TXFD might be enabled so
that only devices that operate at 100 Mbps can communicate with that
port.
end of the segment about its capabilities. The capabilities of a port (25 or
26) with an FE-100TX installed are 10BASE-T, 10BASE-TFD (full
duplex mode), 100BASE-TX and 100BASE-TXFD (full duplex mode).
In normal operation, with all capabilities enabled, the FE-100TX
“advertises” that it has the ability to operate in any mode. The Network
Manager may choose to set up the port so that only a portion of the
available capabilities are advertised and the others are disabled. For
example, only 100BASE-TX and 100BASE-TXFD might be enabled so
that only devices that operate at 100 Mbps can communicate with that
port.
describes how to enable or disable advertised
modes.
5.15.1
Configuring an FE-100FX or FE-100F3
When an FE-100FX or FE-100F3 is installed in port 25 or 26, it must be
manually set to operate in the same technology as the device at the other
end of the connected segment.
manually set to operate in the same technology as the device at the other
end of the connected segment.
provides instructions for
manually configuring the port with an FE-100FX or FE-100F3 interface.
5.15.1.1 Setting the FE-100FX or FE-100F3
Operational Mode
Use the Desired Oper. Mode field to set the active technology. This field
toggles between 100Base-FX and 100Base-FXFD (full duplex). To set the
active technology through Local Management, proceed as follows:
toggles between 100Base-FX and 100Base-FXFD (full duplex). To set the
active technology through Local Management, proceed as follows:
1.
Use the arrow keys to highlight the Desired Oper. Mode field.
2.
Use the SPACE bar to select 100Base-FX or 100Base-FXFD (full
duplex).
duplex).
3.
Press ENTER. The port now operates in the chosen mode.
4.
Use the arrow keys to highlight the SAVE command. Press ENTER.
The message “SAVED OK” displays and Local Management saves
the changes to memory.
The message “SAVED OK” displays and Local Management saves
the changes to memory.