Lantronix 900-510 用户手册
3: Installation
SLB™ Branch Office Manager User Guide
24
Relative Humidity
Operating: 10% to 90% non-condensing
Storage: 10% to 90% non-condensing
Storage: 10% to 90% non-condensing
Heat Flow Rate
68 BTU per hour
Current measurement
accuracy
accuracy
± 12%
1
The max input/output current is de-rated to 12A when using the supplied NEMA
5-15P (15A) cable (p/n SLPP012310-01).
2
The max input/output current is de-rated to 16A when using the optional NEMA
5-20P (20A) cable (p/n SLPP012410-01, SLPP012510-01, SLPP012610-01).
Physical Installation
To install the SLB branch office manager in a rack:
1. Place the SLB device in a 19-inch rack.
Warning:
Be careful not to block the air vents on the sides of the SLB
branch office manager. If you mount the SLB in an enclosed rack, we
recommended that the rack have a ventilation fan to provide adequate
airflow through the SLB.
recommended that the rack have a ventilation fan to provide adequate
airflow through the SLB.
2. Connect the serial device(s) to the SLB device ports. See
on page
3. Install any PC Cards you intend to use. If you install a modem card, connect to the
phone line. See
4. You have the following options:
a) To configure the SLB branch office manager using the network, or to monitor
on page
b) To configure the SLB branch office manager using a dumb terminal or a
computer with terminal emulation, connect the terminal or PC to the SLB
console port. See
console port. See
on page
5. Connect the power cord, and apply power. See
6. Wait approximately a minute and a half for the boot process to complete.
When the boot process ends, the SLB host name and the clock appear on the LCD
display.
display.
Now you are ready to configure the network settings as described in