Juniper Networks 200 用户手册

下载
页码 40
Chapter 3 Configuring the Device
26
User’s Guide
5.
(Optional) By default, the console times out and terminates automatically after 
10 minutes of idle time. To change this timeout interval, execute the following 
command:
set console timeout number
where number is the length of idle time in minutes before session termination. 
To prevent any automatic termination, specify a value of 0.
Starting a Console Session Using Dialup
Each NetScreen-200 Series device provides a modem port that allows you to establish a 
remote console session using a dialup connection through a 9600 bps modem cabled to the 
modem port. Dialing into the modem establishes a dialup console connection.
Establishing a GUI Management Session
To access the NetScreen-200 Series device with the WebUI management application:
1.
Connect your computer (or your LAN hub) to the ethernet1 port using a 
Category-5 Ethernet cable.
2.
Launch your browser, enter the IP address of the ethernet1 interface in the 
URL field, and then press Enter.
For example, if you assigned the ethernet1 interface an IP address of 
10.100.2.183
/16, enter the following:
10.100.2.183
The NetScreen WebUI software displays the login prompt.
3.
Enter netscreen in both the Admin Name and Password fields, then click 
Login. (Use lowercase letters only. The Admin Name and Password fields are 
both case sensitive.)
Note: 
The Terminal type for dialup sessions must be vt100. For example, in Hilgreave 
HyperTerminal (a commonly-used terminal application), select Connect >> Remote 
System
, then select vt100 from the Term Type menu.