DELL 9.8(0.0) 用户手册

Version

Description

8.3.7.0

Introduced on the S4810.

7.7.1.0

Introduced on the S-Series.

7.6.1.0

Introduced on the C-Series.

7.4.1.0

Introduced on the E-Series.

Usage 
Information

Before LLDP can be configured on an interface, it must be enabled globally from 
CONFIGURATION mode. This command places you in LLDP mode on the 
interface; it does not enable the protocol.

When you enter the LLDP protocol in the Interface context, it overrides global 
configurations. When you execute the no protocol lldp from INTERFACE 
mode, interfaces begin to inherit the configuration from global LLDP 
CONFIGURATION mode.

show lldp neighbors

Display LLDP neighbor information for all interfaces or a specified interface.

S4820T

Syntax

show lldp neighbors [interface] [detail]

Parameters

(OPTIONAL) Enter the following keywords and slot/port or 
number information:

• For a 10-Gigabit Ethernet interface, enter the keyword 

TenGigabitEthernet then the slot/port information.

• For a 40-Gigabit Ethernet interface, enter the keyword 

fortyGigE then the slot/port information.

detail

(OPTIONAL) Enter the keyword detail to display all the TLV 
information, remote management IP addresses, timers, and 
LLDP tx and rx counters.

Defaults

none

Command 
Modes

EXEC Privilege

Command 
History

This guide is platform-specific. For command information about other platforms, 
refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version

Description

9.7(0.0)

Introduced on the S6000-ON.

Link Layer Discovery Protocol (LLDP)

1157