Raritan Engineering KX2-864 用户手册
Chapter 7: Device Management
165
Blade chassis
Required/recommended action
Dell PowerEdge
1855/1955
1855/1955
•
Disable the iKVM GUI screensaver. An Authorize dialog will
appear if this is not done and will prevent the iKVM from
operating correctly.
appear if this is not done and will prevent the iKVM from
operating correctly.
•
Exit the iKVM GUI menu before attaching Dell's chassis to a
Raritan CIM. iKVM may not work correctly if this is not done.
Raritan CIM. iKVM may not work correctly if this is not done.
•
Configure the iKVM GUI Main menu to select target blades by
Slot, not by Name. iKVM may not work correctly if this is not
done.
Slot, not by Name. iKVM may not work correctly if this is not
done.
•
Do not designate any slots for scan operations in the iKVM GUI
Setup Scan menu or the iKVM may not work properly.
Setup Scan menu or the iKVM may not work properly.
•
To avoid having the iKVM GUI display upon connecting to the
blade chassis, set the Screen Delay Time to 8 seconds.
blade chassis, set the Screen Delay Time to 8 seconds.
•
Recommend that 'Timed' and 'Displayed' be selected during
iKVM GUI Flag Setup. This will allow you to visually confirm
the connection to the desired blade slot.
iKVM GUI Flag Setup. This will allow you to visually confirm
the connection to the desired blade slot.
IBM/Dell
Auto-Discovery
Auto-Discovery
•
It is recommended that Auto-Discovery be enabled when
applying blade level access permissions. Otherwise, set access
permissions on a blade-chassis wide basis.
applying blade level access permissions. Otherwise, set access
permissions on a blade-chassis wide basis.
•
Secure Shell (SSH) must be enabled on the blade chassis
management module.
management module.
•
The SSH port configured on the blade chassis management
module and the port number entered on the Port Configuration
page must match.
module and the port number entered on the Port Configuration
page must match.
IBM KX2 Virtual
Media
Media
•
Raritan Dominion KX II Virtual Media is supported only on IBM
BladeCenter Models H and E. This requires the use of the
D2CIM-DVUSB. The black D2CIM-DVUSB Low-Speed USB
connector is attached to the Administrative Management
Module (AMM) at the rear of the unit. The gray D2CIM-DVUSB
High-Speed USB connector is attached to the Media Tray (MT)
at the front of the unit. This will require a USB extension cable.
BladeCenter Models H and E. This requires the use of the
D2CIM-DVUSB. The black D2CIM-DVUSB Low-Speed USB
connector is attached to the Administrative Management
Module (AMM) at the rear of the unit. The gray D2CIM-DVUSB
High-Speed USB connector is attached to the Media Tray (MT)
at the front of the unit. This will require a USB extension cable.