Nortech Systems RS-232/TERM 用户手册

A two-camera breakout cable is standard with Adept vision systems. Adept sells an 
optional four-camera cable that is used for connecting cameras to the sAVI board. The 
camera cables connect to the Camera connector on the front of the SmartController CX. 
This connector contains support for two strobe connections through a breakout cable. See 
Tables 

 to 

 for pin and signal information for the cables.

For single camera, non-reset, non-strobe applications, the two-camera breakout cable is 
sufficient. Dual megapixel camera applications require a four-camera cable because of 
current limitations (see 

).

Although the breakout cables route the signals away from the chassis, they do not connect 
directly to the camera. To connect to the cameras, you must use an extension cable. Adept 
offers a 10 meter cable for this purpose. These cables can also be purchased from 
Intercon 1. Contact Adept Applications Support for current Intercon 1 part numbers.

You can contact Intercon 1 (division of Nortech Systems) at:

Phone: 800-237-9576   or 218-765-3329

This cable, available from Adept (P/N 10332-01367), has a 44-pin D-sub connector on one 
end, and it breaks out to two 12-pin Hirose- style camera connectors on the other end. The 
length of the cable is 1.8 meters (70 inches).

The sAVI board supplies 12 VDC power for cameras through this cable. The current rating 
is 500 mA maximum per camera, with a combined maximum of 1 A.

ADEPT

CABLE ASSY. CAMERA

INTERFACE 2X

CAM 1

CAM 2

1

31

15

44

To Camera connector on
SmartController CX