National Instruments 1128 用户手册

© National Instruments Corporation

5.

Connect the HV8-BAN4 cable from the DMM to the HVAB connector 
behind SCXI slot 4.

6.

Connect the SH9MD-9MD cable from the DMM to the AUX IN 
connector.

7.

You can install any additional SCXI-1127/1128 modules in any slot 
that has an HVAB-backplane adapter behind it.

To install your DMM in PXI slot 8, follow these steps:

1.

Install your DMM in PXI slot 8.

2.

In the SCXI subsystem, install the 2-slot HVAB-backplane adapter 
behind SCXI slots 3 and 4.

3.

Install additional 1-slot HVAB-backplane adapters behind SCXI slots 
1 and 2 if needed.

4.

Install the 8-position HVAB plugs to connect the HVAB-backplane 
adapters as needed.

5.

Connect the HV8-BAN4 cable from the DMM to the HVAB connector 
behind SCXI slot 4 of the SCXI subsystem.

6.

You can install any additional SCXI-1127/1128 modules in any slot 
that has an HVAB-backplane adapter behind it.

The SH9MD-9MD is not required for this configuration.

You will need the following items to complete the installation:

•

PXI-1011 chassis with the SCXI-1127/1128 modules installed

•

HV8-BAN4 cable

•

DMM

•

1/8 in. flathead screwdriver

Consult your PXI-1011 and DMM documentation for additional 
instructions and warnings. Your SCXI-1127/1128 modules and any other 
SCXI modules should already be installed in the chassis according to their 
installation instructions. Before you proceed with your connections, make 
sure you turn off y our SCXI chassis.