National Instruments 1128 用户手册
© National Instruments Corporation
D-1
D
SCXI-1127/1128
Front Connector
Front Connector
This appendix contains connector diagrams for the SCXI-1127/1128
switch cards. The diagrams also show the signal names that are used
when the modules are in 2-wire mode, 1-wire mode, 4-wire mode, and
4
switch cards. The diagrams also show the signal names that are used
when the modules are in 2-wire mode, 1-wire mode, 4-wire mode, and
4
× 8 matrix configuration.
When you connect a custom terminal block or cable it is important that you
incorporate the safety interlock scheme into the terminal block/cable. You
do this by connecting the +5 V (ISO)_HVAB_EN signal to the +5 V (ISO)
signal. These signals are shown in the following figures. Refer to Table D-1
for descriptions of signal names.
incorporate the safety interlock scheme into the terminal block/cable. You
do this by connecting the +5 V (ISO)_HVAB_EN signal to the +5 V (ISO)
signal. These signals are shown in the following figures. Refer to Table D-1
for descriptions of signal names.