Fujitsu eLux NG S26361-F2600-L134 用户手册
产品代码
S26361-F2600-L134
www.
myelux
.com
eLux
®
NG
Build # 27
84
3.13.6.2 D-Link DWL-G520 Network Card
eLux NG supports the DWL-G520 network card from D-Link Corporation. No adapter is
required and it is not necessary to disable the onboard Ethernet controller in the Thin Client’s
BIOS Setup. This feature is not available for all hardware platforms.
Enabling wireless LAN on your device involves the following:
1. Installing the required firmware
2. Inserting the card
3. Configuring network hardware settings
4. Configuring network hardware settings and entering the WEP key for encrypted transfer
required and it is not necessary to disable the onboard Ethernet controller in the Thin Client’s
BIOS Setup. This feature is not available for all hardware platforms.
Enabling wireless LAN on your device involves the following:
1. Installing the required firmware
2. Inserting the card
3. Configuring network hardware settings
4. Configuring network hardware settings and entering the WEP key for encrypted transfer
To install the wireless LAN firmware
To use wireless LAN you must install the following firmware:
1. Start ELIAS NG and add the following packages to the device’s IDF:
1. Start ELIAS NG and add the following packages to the device’s IDF:
• WLAN DLINK DWL-G520 (wireless_g520) This FPM is found in the base OS
package.
Note: If you cannot activate this FPM, remove the “Cisco Aironet Utility” (airo) EPM from
the IDF first.
the IDF first.
2. Save the IDF and exit ELIAS NG.
3. Install the software on the Thin Client by performing a firmware update over Ethernet.
3. Install the software on the Thin Client by performing a firmware update over Ethernet.
To insert the wireless card
Insert the card into your device according to the directions that came with the card.