3com 8800 用户手册

C

HAPTER

 4: I

NSTALLATION

 

AND

 

TESTING

If you are installing the optional PoE DIMM module, use the following instructions. 

The technical specifications of PoE DIMM (Dual In-line Memory Module) are listed in 
Table 5.

■

With the reverse insertion prevention design, you can only insert the module in the 
right direction.

■

The PoE DIMM module is only supported on the PoE I/O module.

■

If no PoE SIMM module is in place, or the module is not fully seated, the interface 
card cannot supply power, even if other functions go well.

The Master and Slave DIMM modules must be used at the same time.

Follow these steps to install the PoE DIMM: 

1 Check the position of the module. 

2 Insert the Master DIMM module into the J15 socket of the interface card and the 

Slave DIMM module into the J16 socket. 

3 Close the locking spring clips until the pins at both ends of the clip snap into the 

notches in the module. 

All items required for installation are contained within the packaging. Additional 
power supply modules are shipped separately. Check the packing list. Rack or frame 
mounting screws are not included.

1 Place unit box in a vertical position near the installation site (equipment cabinet or 

rack).

2 Carefully remove the crate top, crate sides, and the packing material. If possible, 

recycle the packing crate and the packing material. If not, dispose of properly 
according to local codes and regulations.

Table 5   Technical specifications of PoE DIMM module

PD67024MUAC 

24 

Master 

AC 

Powered devices 
compliant with IEEE 
802.3af or the 
legacy standard 

PD67024S 

24 

Slave 

AC/DC 

According to Master