3com 5500 用户手册

■

Configuration on the switch.

# Enable the information center.

<3Com> system-view

[3Com] info-center enable 

# The system outputs information of all modules through channel6 by default. 
Therefore, you need to disable the function first.

[3Com] undo info-center source default channel channel6 

# Set the host with an IP address of 10.153.116.65 to be the log host, set to send 
log and trap information with severity higher than informational to the log host 
through the same channel channel6, and set the information source module to 
L2INF.

[3Com] info-center loghost 10.153.116.65 channel 6

[3Com] info-center source L2INF channel 6 log level informational st

ate on trap level informational state on debug state off 

■

Configuration on the log host.

For the configuration of the log host, see “Configuration Procedure” on page 311 
and “Configuration Procedure” on page 313.

The following takes receiving log information through log host software on a 
Windows operating system as an example:

# The log host software used in this example is TFTPD32, the version of which is as 
follows:

Switch 5500

Release V03.02.04 

All versions

Switch 5500G

Release V03.02.04 

All versions

Switch 4500

Release V03.03.00 

All versions

Switch 4210

Release V03.01.00 

All versions