3com 3CRWX120695A WXR100 用户手册
Modifying Basic Switch Parameters
175
Deleting Auto DAPs
3WXM automatically updates an Auto DAP’s information in the network
plan when the DAP either is converted into a configured MAP, or reboots
and then connects to a different WX.
plan when the DAP either is converted into a configured MAP, or reboots
and then connects to a different WX.
However, if an Auto DAP leaves the network without being converted
into a statically configured MAP or connecting to a different WX, 3WXM
continues to list the DAP as a device being managed by the WX.
into a statically configured MAP or connecting to a different WX, 3WXM
continues to list the DAP as a device being managed by the WX.
In this case, you can manually delete the MAP from the WX switch’s Auto
DAP list.
DAP list.
This procedure does not delete an active Auto DAP. To remove an Auto
DAP that is still attached to the network, remove it from the network.
(Unplug it or power it down.) Then use this procedure to remove it from
the Auto DAP list.
DAP that is still attached to the network, remove it from the network.
(Unplug it or power it down.) Then use this procedure to remove it from
the Auto DAP list.
To delete an Auto DAP
1 Select the Configuration tool bar option.
2 In the Organizer panel, select the WX switch.
3 In the Task List panel, select Delete Auto APs.
The Delete Auto APs wizard appears. The MAPs that were configured
using a Distributed MAP template are listed.
using a Distributed MAP template are listed.
4 Select the Auto DAP that is no longer on the network.
5 Click Next.
6 Click Finish.
Launching a Telnet
Management Session
with the Switch
This option is available only if the switch is running and can be reached
through the network by 3WXM Services. This option also requires the
Managed option for the switch to be enabled. (See step 6 in “Modifying
Basic Switch Parameters” on page 170.)
through the network by 3WXM Services. This option also requires the
Managed option for the switch to be enabled. (See step 6 in “Modifying
Basic Switch Parameters” on page 170.)
1 Select the Configuration tool bar option.
2 In the Organizer panel, select the WX switch.
3 In the Task List panel, select Launch Telnet.