3com 4500 26-PORT 用户手册

 Sets the current Ethernet port as an edge port.  

 Sets the current Ethernet port as a non-edge port. 

Use the 

 command to configure the current port as an 

edge port. 

Use the 

 command to configure the current port as a 

non-edge port. 

Use the 

 command to restore the default setting. 

By default, all the Ethernet ports of the bridge are configured as non-edge ports. 

If the current Ethernet port is connected to other Switch, you can use the 

 or 

 command to specify it as a 

non-edge port. The stp edged-port enable command can be used to configure the 
current Ethernet port as an edge port.  All the Ethernet ports have been set to 
non-edge ports by default. You can configure the Ethernet ports directly 
connected to the user terminals as edge ports, so that they can transition to 
forwarding state quickly. 

Related command: 

.

To set Ethernet1/0/1 as a non-edge port, enter the following:

<4500>system-view

System View: return to User View with Ctrl+Z.

[4500]interface Ethernet1/0/1

[4500-Ethernet1/0/1]stp edged-port disable

Ethernet Port View

none

Use the 

 command to enable loop protection function. 

Use the 

 command to restore the setting.

By default, the loop protection function is not enabled.