3com 3.01.01 用户手册
IS-IS
123
Execute the display command in all views to display the IS-IS configuration, and
to verify the effect of the configuration. Execute the debugging command in user
view to debug the IS-IS module.
to verify the effect of the configuration. Execute the debugging command in user
view to debug the IS-IS module.
Integrated IS-IS
Configuration Example
As is shown in Figure 11, Switches A, B, C and D belong to the same autonomous
system. The IS-IS routing protocol is run in these four switches to implement route
interconnection. In network design, switches A, B, C and D belong to the same
area.
system. The IS-IS routing protocol is run in these four switches to implement route
interconnection. In network design, switches A, B, C and D belong to the same
area.
This example shows only the IS-IS configuration. You must also configure IP
addresses on the vlan interface of each switch.
addresses on the vlan interface of each switch.
Table 88 Displaying and Debugging IS-IS
Operation
Command
Display IS-IS LSDB
display isis lsdb [ [ l1 | l2 | level-1 | level-2 ] |
[ [ LSPID | local ] | verbose ]* ]*
[ [ LSPID | local ] | verbose ]* ]*
Display IS-IS SPF calculation log
display isis spf-log
Display IS-IS routing information
display isis route
Display IS-IS neighbor information
display isis peer [ verbose ]
Display mesh group information
display isis mesh-group
Debug IS-IS adjacency packets
debugging isis adjacency
Debug IS-IS LSP checksum errors
debugging isis checksum-error
Debug IS-IS local update packets
debugging isis self-originated-update
Debug IS-IS LSP errors.
debugging isis general-error
Debug IS-IS SNP packets
debugging isis snp-packet
Debug IS-IS SPF events.
debugging isis spf-event
Debug IS-IS SPF computing statistics
debugging isis spf-summary
Debug IS-IS SPF triggers.
debugging isis spf-timer
Debug IS-IS update packets
debugging isis update-packet