SMC Networks 1000BASE-X 用户手册

3-11

Use the IP Configuration screen to set the bootup option, configure the IP 
address for the on-board management agent, or set the number or 
concurrent Telnet sessions allowed. The screen shown below is described 
in the following table. 

IP State

USER-CONFIG Specifies whether IP functionality is enabled via 

manual configuration, or set by Boot Protocol 

(BOOTP). Options include: 
USER-CONFIG - IP functionality is enabled 

based on the default or user specified IP 

Configuration. (This is the default setting.)
BOOTP Get IP - IP is enabled but will not 

function until a BOOTP reply has been received. 

BOOTP requests will be periodically broadcast 

by the switch in an effort to learn its IP address. 

(BOOTP values can include the IP address, 

default gateway, and subnet mask.)

IP Address

10.1.0.1

IP address of the switch you are managing.  The 

switch supports SNMP over UDP/IP transport 

protocol. In this environment, all systems on the 

Internet, such as network interconnection 

devices and any PC accessing the on-board agent 

(or running EliteView) are assigned an IP 

address. Valid IP addresses consist of four 

decimal numbers, of 0 to 255, separated by 

periods. Anything outside of this format will not 

be accepted by the configuration program.