SMC Networks 1000BASE-X 用户手册
R
EQUIRED
C
ONNECTIONS
1-3
In-Band Connections
Prior to accessing the Network Management Module via a network
connection, you must first configure it with a valid IP address, subnet
mask, and default gateway using an out-of-band connection or the
BOOTP protocol.
connection, you must first configure it with a valid IP address, subnet
mask, and default gateway using an out-of-band connection or the
BOOTP protocol.
After configuring the switch’s IP parameters, you can access the on-board
configuration program from anywhere within the attached network. The
on-board configuration program can be accessed using Telnet from any
computer attached to the network. The switch and stack can also be
managed by any computer using a Web browser (Internet Explorer 4.0, or
Netscape Navigator 4.0 or above), or from a network computer using
network management software such as EliteView.
configuration program from anywhere within the attached network. The
on-board configuration program can be accessed using Telnet from any
computer attached to the network. The switch and stack can also be
managed by any computer using a Web browser (Internet Explorer 4.0, or
Netscape Navigator 4.0 or above), or from a network computer using
network management software such as EliteView.
Notes: 1. By default BOOTP is disabled. To enable BOOTP, see “IP
2. Use the Network Configuration menu to specify the maximum
number of simultaneous Telnet sessions that are supported by
the system (up to four).
the system (up to four).
3. The on-board program only provides access to basic
configuration functions. To access the full range of SNMP
management functions, you must use SNMP- based network
management software, such as SMC’s free EliteView software.
management functions, you must use SNMP- based network
management software, such as SMC’s free EliteView software.