Siemens 411 用户手册

MICROMASTER 411 & COMBIMASTER 411    Operating Instructions 

 

6SE6400-5CA00-0BP0 

23

 

 

♦ 

This equipment must be grounded. 

♦ 

To ensure safe operation of the equipment, it must be installed and 
commissioned by qualified personnel in full compliance with the warnings laid 
down in these operating instructions. 

♦ 

Take particular note of the general and regional installation and safety 
regulations regarding work on dangerous voltage installations (e.g. EN 
50178), as well as the relevant regulations regarding the correct use of tools 
and personal protective gear. 

♦ 

The Power supply, DC and motor terminals, can carry dangerous voltages 
even if the inverter is inoperative; wait 5 minutes to allow the unit to 
discharge after switching off before carrying out any installation work. 

4 

 

Remove the MICROMASTER 411 installation kit from the packing. Check packing 
box contents against the advice note supplied. 

The installation kit should comprise the following items: 

1. Inverter 

cover 

2. Terminal 

Housing 

3.  Filter Module & screws (captive) 
4.  Input – Output Board & screws (captive) 
5. Earth 

Lead 

6.  10 Off Terminal Jumpers 
7.  Getting Started Guide and CD 
8.  2 off Glands M25 IP68 withO-ring 
9.  2 off M25 sealing plugs 

10.  2 off M25 Gland Fixing Plates 
11.  2 off U-clamp & screws (for earth/ground connection) 
12.  4 off M4 Inverter to Motor fixing screws  

(CSC only: additional 4 off M5 screws) 

13. Motor 

Cable 

Sheath 

14.  1 off Motor Gasket (CSC only: additional 1 off Motor Gasket) 
15.  1 off M12 connector blanking plug 

 

Any defective or missing items should be reported immediately to your local 
Siemens Distributor or Sales Office.