Sun Microsystems 5802 用户手册
Chapter 5
Managing Switches
141
Network DNS Configuration
The Network Properties dialog has two tabs: IP and DNS. Click the DNS tab to open
the Network Properties DNS dialog (
the Network Properties DNS dialog (
). Use the Network Properties DNS
dialog to enable the DNS Client on the switch and the DNS server to map domain
names to IP addresses.
names to IP addresses.
describes the DNS configuration parameters.
IPv6 Configuration
Discovery
Choose one of the following methods by which to
assign the IP address:
• Static — uses the IP configuration parameters
assign the IP address:
• Static — uses the IP configuration parameters
entered in the Network Properties dialog
• Dhcpv6 (Dynamic Host Configuration Protocol
version 6)
— acquires the IP configuration from a
DHCP server. If no satisfactory lease is obtained, the
DHCP client attempts to use the previously
configured lease. If the previous lease cannot be
used, no IP address will be assigned to this switch in
order to avoid an IP address conflict.
DHCP client attempts to use the previously
configured lease. If the previous lease cannot be
used, no IP address will be assigned to this switch in
order to avoid an IP address conflict.
• Ndp — Neighbor Discovery Protocol. Part of the
Stateless Address Auto configuration protocol. It
replaces the Address Resolution Protocol used with
IPv4.
replaces the Address Resolution Protocol used with
IPv4.
Config IPv6 Address
IPv6 address for the Ethernet port
Gateway
IPv6 gateway address
TABLE 5-7
Network Properties - DNS Configuration
Parameter
Description
DNS Options
DNS Client
Domain Name Service client
Local Hostname
Name of the local host
TABLE 5-6
Network Properties- IP Configuration
Parameter
Description