Sun Microsystems 816-0830-12 用户手册

Chapter 4

Hardware Installation

▼

To Attach Mounting Rails for Two 16-Port
Switches

Each 16-port switch comes with two identical mounting rails. There is no difference
between the left rail and the right rail.

1. Before you install the rails into the cabinet, loosely start two stopper screws into

each rail (see

FIGURE 4-3

2. Working from the rear of the cabinet, loosely start two screws into the cabinet for

each mounting rail, one at each end (see

FIGURE 4-3

Refer to the online Rackmount Placement Matrix for the correct hole positions for your
configuration.

Note –

Install the screws into the cabinet holes before you place the rails.

FIGURE 4-3

Attaching the Mounting Rails for a 16-port Switch

3. Working from the front of the cabinet, install the mounting rails by sliding the

keyhole slot in the rail onto the screw.

In a two-switch configuration install the lower rail before you install the upper one.

Stopper screw hole

Preinstalled screws