Avaya M770 用户手册
Chapter 2
Getting Started
Avaya M770 ATM Switch User’s Guide
15
•
For the switches that are capable of becoming PGLs (as determine in step 4) do
the following:
1
the following:
1
Configure the level scope as determine in step 6 for all levels (1-5) using the
command:
command:
2
Configure the leadership priority of the node in the lower level to a value
greater than 0.
greater than 0.
3
Configure the Administrative Status of the node in the next higher level to
Up
Up
•
Repeat the last step for all levels you have in the hierarchy.
Connecting to an end-station or edge device not supporting ILMI
If you are attaching an end-station or edge device that does not support ILMI then
you must configure a route to that device. For example, if you are connecting an
Avaya M400 Gate Switch LSA+ module to port 8.4.0 on the M770 ATM Switch, you
should configure the static routing by performing the following steps:
[assume that the ATM address of the LSA+ is
39.01.00.00.00.00.00.00.00.00.00.00.00.00.40.od.64.02.de.00]
you must configure a route to that device. For example, if you are connecting an
Avaya M400 Gate Switch LSA+ module to port 8.4.0 on the M770 ATM Switch, you
should configure the static routing by performing the following steps:
[assume that the ATM address of the LSA+ is
39.01.00.00.00.00.00.00.00.00.00.00.00.00.40.od.64.02.de.00]
Note:
The ATM address should not include the selector.
M15-155s8:/>/route pnni config level set <level (1-5)> <level scope (1-
104)>
M15-155s8:/>/route pnni config pgle set <level-x (1-4)> 1 <leadership
priority (1-205)>
M15-155s8:/>/route pnni config admin set <level-x+1(2-5)> up
M15-155s8:/>route add
39.01.00.00.00.00.00.00.00.00.00.00.00.00.40.od.64.02.de 8.4.0