Avaya M770 用户手册
Chapter 6
Managing Virtual Ports
76
Avaya M770 ATM Switch User’s Guide
To reset the profile parameter for a virtual port, use the
vport reset profile
command.
Resetting the stack type parameter
If you reset the virtual port’s stack type parameter, the port will re-learn the stack
type when it is enabled and a remote device is connected. For more information
about this parameter, see “Setting the stack type parameter” on page 69.
type when it is enabled and a remote device is connected. For more information
about this parameter, see “Setting the stack type parameter” on page 69.
Note:
You must disable the virtual port before you can change or reset any virtual
port parameters. For more information about how to disable a virtual port, see
“Disabling a virtual port” on page 65.
“Disabling a virtual port” on page 65.
To reset the stack type parameter for a virtual port, use the
vport reset
stacktype
command.
Resetting the signalling VPC VPI range
To reset the VPC VPI range that was previously assigned for Switched Virtual
Paths, use the following command:
Paths, use the following command:
Note:
You must disable the virtual port before you can change or reset any virtual
port parameters. For more information about how to disable a virtual port, see
“Disabling a virtual port” on page 65.
“Disabling a virtual port” on page 65.
Command:
M15-155s8:/>vport reset profile <vport id>
Example:
M15-155s8:/>vport reset profile 8.1.0
Parameter:
<vport
id>
The virtual port in the form <slot>.<port>.<virtual port number>.
Command:
M15-155s8:/>vport reset stacktype <vport id>
Example:
M15-155s8:/>vport reset stacktype 8.1.0
Parameter:
<vport id>
The virtual port in the form <slot>.<port>.<virtual port number>
Command:
M15-155s8:/>vport reset sigvpcvpirange <vport id>
Example:
M15-155s8:/> M15-155Fs2:/> vport reset sigvpcvpirange 2.15.0
Parameter:
<vport id>
The virtual port in the form <slot>.<port>.0
Output
Clearing sigvpcvpcirange value...
Done!