Brocade Communications Systems 8770-4 用户手册

Switch slots

Switch slots are coded and numbered to differentiate between management module slots, switch fabric module 
slots, and line card slots. Management modules (MM) must be installed only in slots M1 and M2. Switch fabric 
modules (SFM) must be installed only in slots S1 through S3. There must be at least one SFM installed in either slot 
S1 or slot S2. The line card slots, L1 through L4, can be filled with either 48x1G, 48x10G, or 12x40G line cards. 
Unused slots must be filled with the correct filler panels to maintain adequate cooling.

Unpacking and installing the Brocade VDX 8770-4

Use the following procedure to unpack and install your Brocade VDX 8770-4.

CAUTION
Use safe lifting practices when moving the product. (C015)

NOTE

A fully populated Brocade VDX 8770-4 weighs approximately 86.18 kg (190 lb) and requires a hydraulic or assisted 
lift to install it.

1. Unpack the Brocade VDX 8770-4.

a. Cut the bands that encircle the packaging.

b. Slide the upper portion of the cardboard shipping box up off the pallet and shipping tray. 

NOTE

The Brocade VDX 8770-4 packaging incorporates a wood pallet and brackets. The switch sits on top of a 
corrugated cardboard shipping tray.

c. Save the packing materials for use when returning a switch.

d. Leave the switch on top of the shipping tray and pallet if the switch must be transported to the installation 

location.

2. Use a pallet jack or other assisted lift to transport the new switch to the installation area.

3. Using the rack mount instructions, install the rack components in the rack and mounting flanges on the switch. 

The rack mount kit and instructions are shipped separately from the switch.

4. Remove the accessory kit (cardboard box), packing foam, and antistatic plastic from the switch and set them 

aside.

5. Remove the foam inserts around the base of the switch.

6. Use a lift to raise the switch to the correct level. If installing the switch in a rack, follow the instructions provided 

by the rack kit manufacturer.

7. If applicable, lock the wheels of the lift.

8. Ensure that the switch is oriented so that the left side and port side (front) have access to intake air.

9. Gently slide the switch onto the final installation surface, ensuring that it remains supported during the transfer.