Belkin F1DS104J 用户手册
11
1
2
3
4
5
6
7
8
section
11
11
Using the KVM Switch
Hot-Key Preceding Sequence Configuration
For users who want to use a preceding sequence other than two consecutive
Scroll Locks, there is also one convenient way to configure it.
1. Press “ScrollLock” + “ScrollLock” + H, and a beeping sound will signal
Scroll Locks, there is also one convenient way to configure it.
1. Press “ScrollLock” + “ScrollLock” + H, and a beeping sound will signal
readiness for a new preceding sequence selection [or press and hold down
the center of the last front-panel button (Button 2 or Button 4) until you
hear three beeps, then release the button].
the center of the last front-panel button (Button 2 or Button 4) until you
hear three beeps, then release the button].
2. Select and press the key you would like to use as your preceding sequence
(SCROLL LOCK, CAPS, F12, NUM LOCK, LEFT_CTRL, RIGHT_CTRL
keys are available for selection), and you will hear a beep for selection
confirmation. Now you can use the new preceding sequence to execute
your hot-key commands.
Note: Each keystroke within a hot-key sequence should be pressed within
two seconds. Otherwise, the hot-key sequence will not be validated.
keys are available for selection), and you will hear a beep for selection
confirmation. Now you can use the new preceding sequence to execute
your hot-key commands.
Note: Each keystroke within a hot-key sequence should be pressed within
two seconds. Otherwise, the hot-key sequence will not be validated.