Barco 26-0507000-00 用户手册
BlendPRO-II • User’s Guide
19
2. Hardware Orientation
BlendPRO-II Rear Panel
6) Outputs
Section
The figure below illustrates the Outputs Section:
Figure 2-3. BlendPRO-II Outputs Section
The Outputs Section includes four digital and four analog outputs:
~
DVI — the four DVI digital outputs are per DDWG 1.0 specifications. All
four are DVI-D (digital, single link, receptacle) using DVI-I connectors.
The DVI outputs are of the same resolution as the inputs.
four are DVI-D (digital, single link, receptacle) using DVI-I connectors.
The DVI outputs are of the same resolution as the inputs.
In Appendix A, refer to the “
” section on page 38
for pinout details.
~
Analog — the four HD-15 analog outputs provide progressive RGB.
Analog syncs can be configured for 5 wire (RGBHV), 4 wire (RGB
composite sync) or 3 wire (sync on green) operation. Please note:
Analog syncs can be configured for 5 wire (RGBHV), 4 wire (RGB
composite sync) or 3 wire (sync on green) operation. Please note:
•
Video components are driven at 700mV peak amplitude (1V for
SOG) at 75 Ohm terminations.
SOG) at 75 Ohm terminations.
•
Sync components (4 and 5 wire) are driven at TTL compatible
levels at 75 Ohm terminations.
levels at 75 Ohm terminations.
•
The analog outputs is driven at the same resolution and in sync
with the DVI outputs.
with the DVI outputs.
•
Data is identical to the data on the DVI outputs, except that the
analog circuits are 10-bit, and thus preserve the 10-bit result of
the data doubling and feathering operations.
analog circuits are 10-bit, and thus preserve the 10-bit result of
the data doubling and feathering operations.
In Appendix A, refer to the “
” section on
page 37 for pinout details.
7) Ethernet
Port
One RJ-45 (Neutrik) connector is provided for Ethernet communications with
BlendPRO-II. Ethernet is the primary means of controlling the BlendPRO-II.
Please note:
BlendPRO-II. Ethernet is the primary means of controlling the BlendPRO-II.
Please note:
~
The Ethernet port is 10/100 Mbit auto-sensing capable.
~
The port is primarily configured to run as a DHCP client, although static
IP can be used if desired.
IP can be used if desired.
In Appendix A, refer to the “
” section on page 39 for pinouts.
OUTPUTS
1
2
3
4
1
2
3
4