Minicom Advanced Systems 5UM70156 V1.1 12 用户手册
KVM.NET
18
Enable DHCP – Enable DHCP to provide you with dynamic IP addressing for IP
Access, if a DHCP server exist.
Access, if a DHCP server exist.
Active – Enable/disable Network activity of the IP Access via KVM.net.
Note: Any change in the Network configuration forces IP Access to restart.
4.3.1.5 The Serial tab elements
Click the Serial tab. The following appears.
Figure 14 The Serial tab
You can access a Serial Network device during an IP Access remote session by
emulating its Serial connection via RS232 (VT100 & TTY). Only users with
administrative privileges can operate a Serial managed Network Devices (such as a
Power management device)
emulating its Serial connection via RS232 (VT100 & TTY). Only users with
administrative privileges can operate a Serial managed Network Devices (such as a
Power management device)
Define the console parameters for controlling Network devices over RS232 via the
IP Access Serial connector.
IP Access Serial connector.
Device Name - type the name of the device (i.e. Power Management; CISCO
router; etc)
router; etc)
Baud Rate, Data Bits, Parity, Stop bits - type the appropriate values according to
the network device specifications, attached to the IP Access.
the network device specifications, attached to the IP Access.
To open the Serial emulation window via remote session refer to the IP Access
User Guide – Configuring Serial devices.
User Guide – Configuring Serial devices.