Minicom Advanced Systems Phantom 用户手册

 

When the Phantom system was first installed, ID numbers were assigned with the auto-numbering process. 
Auto numbering gives each Phantom Remote a sequential number according to its physical location in the 
daisy chain. Remote units can be renumbered according to their physical location or by manually choosing the 
numbers you desire.  

Renumbering is done using Phantom Numbering software. The software is on the Marketing & Documentation 
CD. 

To renumber the Remotes the Phantom system must be connected and switched on.  

To run the software, connect the RS232 Serial cable to the computer containing the software, and to the 
Phantom Manager. See chapter 5 of the Installation guide. 

•  Pentium 166 or higher computer 
•  16Mb RAM 
•  Windows 98, NT4 (SP6), 2000, ME or XP  
•  Free Serial port 

To use the Numbering software, the OSD must be in the Numbering mode.  

1. Press 

Shift, Shift to display the OSD. 

2. Press 

F10 to enter the Numbering mode. The Firmware Upgrade label appears. See Figure 

 

 

5-1 The Firmware Upgrade label 

Start the Marketing & Documentation CD and choose Phantom Utilities Softpack. The Phantom Softpack 
window appears. The Numbering Software can be installed onto the computer or operated directly from the 
CD. To install the software choose Install Phantom Numbering Software. 

To run the software: 

Select Run Phantom Numbering Software. The Phantom Numbering window appears. See Figure