Motorola CPCI-6115 用户手册

After all peripheral modules have been installed and all of the appropriate jumpers have been 
set, you are ready to install the transition module in its chassis slot. At this point, follow the steps 
below:

To Install the rear transition module, follow these steps:

1. Attach an ESD strap to your wrist. Attach the other end of the strap to the chassis 

as a ground. The ESD strap must be secured to your wrist and to ground throughout 
the procedure.

2. Perform an operating system shutdown. Turn the AC or DC power off and remove 

the AC cord or DC power lines from the system. Remove the chassis or system 
cover(s) as necessary for access to the chassis backplane.

3. With the CPCI-6115-MCPTM in the correct vertical position that matches the pin 

positioning of the backplane, carefully slide the transition module into the 
appropriate slot and seat tightly into the backplane. Refer to 

 for the correct board/connector orientation.

4. Secure in place with the screws provided, making good contact with the transverse 

mounting rails to minimize RF emissions.

5. Replace the chassis or system cover(s), reconnect the system to the AC or DC 

power source and turn the equipment power on, or if hot-swapping, you may now 
install the CPCI-6106.