Motorola CPCI-6115 用户手册

The following equipment is required to complete an CPCI-6115 system:

z

CompactPCI or compatible system enclosure

z

System console terminal

z

Operating system (and/or application software)

z

Disk drives (and/or other I/O) and controllers

The CPCI-6115 baseboards are factory-configured for I/O handling via its front panel, installed 
PMCs or a rear transition module that is specifically designed for the CPCI-6115 product family.

This section discusses certain hardware and software tasks that may need to be performed 
prior to installing the board in a CompactPCI or PICMG 2.9 compliant chassis.

To produce the desired configuration and ensure proper operation of the CPCI-6115, you may 
need to carry out certain hardware modifications before installing the module.

Most options on the CPCI-6115 are software configurable. Configuration changes are made by 
setting bits in control registers after the board is installed in a system. The control registers are 
described in the CPCI-6115 CompactPCI Single Board Computer Programmer's Reference 
Guide, and other vendor publications.

Jumpers are used to control those options that are not software configurable. These jumper 
settings are described further on in this section.

Install the PMC Module (if required)

Install the CPCI-6115 in the chassis.

Install the transition module.

Connect any other equipment you will be 
using.

Power up the system