Motorola CPCI-6115 用户手册

This chapter provides hardware preparation and installation instructions for the CPCI-6115-
MCPTM transition module. Refer to 

 for pin 

assignments.

The CPCI-6115-MCPTM transition module provides additional I/O capabilities to the CPCI-
6115 SBC. The transition module is installed directly in the CompactPCI backplane in the rear 
transition board bay of the chassis and interfaces with the CPCI-6115 SBC through the J3 and 
J5 connectors.

Rear panel connectors on the CPCI-6115-MCPTM include one of two configurations: two RJ-
45 connectors for 10/100/1000BaseTx Ethernet and one RJ-45 connector for asynchronous 
serial port, COM1 (CompactPCI version); or four RJ-45 connectors for asynchronous serial 
ports, COM1, COM2, COM3 and COM4 (MXP version). Only COM1 and COM2, however, are 
available on the CPCI-6115 SBC for use with the transition module. An additional two serial 
ports and the one EIDE channel are available on J3 and J5 from the baseboard.

The transition module supports two single-wide (74mm wide by 69mm long) PMC I/O modules. 
PMC I/O pins 1 through 64 of each PMC slot on the CPCI-6115 SBC are routed from the J3 
and J5 connectors to the PMC I/O (PIM1 and PIM2) on the transition module. For a detailed 
description of PMC I/O modules refer to the section titled 

.

Before installing your transition module, ensure that you have performed all tasks as described 
in 

 for installing the CPCI-6115 prior to 

configuring and installing the transition module.