Motorola WS5100 用户手册

下载
页码 364
6-34   WS5100 Series Switch System Reference Guide
 
13.Click 
Cancel
 to close the dialog without committing updates to the running configuration. 
6.6.3 Configuring NAT Interfaces
The NAT Interface is the VLAN used to route switch data traffic between the source and destination address 
locations within the switch-managed network. Any of the default VLANs is available as the NAT interface, 
in addition to any other VLANs you may have created. In addition to selecting the VLAN, specify the Inside 
or Outside NAT type.
To view and configure a NAT interface:
1. Select 
Security 
> 
NAT
 from the main menu tree.
2. Click on the
 Interfaces
 tab. 
3. Refer to the following information as displayed within the 
Interface
 tab: 
4. To Edit an existing interface, select it from the list of available interfaces and click the 
Edit
 button.
An Edit Interface screen displays allowing the user to modify the VLAN and interface type (inside or 
outside) used. 
5. If an interface is obsolete or of no use to the NAT translation process, select it and click the 
Delete
 
button to remove it from the list of interfaces available
Interface
Displays the particular VLAN used as the inside or outside NAT type. All defined VLANs are 
available from the drop-down menu for use as the interface.
Type
Displays the NAT type as either:
• Inside - The set of switch-managed networks subject to translation. These are the internal 
addresses you are trying to prevent from being exposed to the outside world.
• Outside - All other addresses. Usually these are valid addresses located on the Internet. 
Outside addresses pose no risk if exposed over a publicly accessible network.