Sun Microsystems 1290 用户手册
Chapter 2
Setting Up
45
2. At the
Enter new password
prompt, type your password.
3. At the
Enter new password again
prompt, re-type your password.
If your password has been lost or forgotten, contact Sun Service for assistance.
▼
To Configure Network Parameters
The Netra 1290 server can be administered from the SC LOM prompt and from the
Solaris software. There are two ways to access the LOM console connection:
Solaris software. There are two ways to access the LOM console connection:
■
Through the SC serial port connection
■
Through a remote (network) connection using the 10/100BASE-T Ethernet port
Note –
The system can be administered solely through the serial port, but if you
want to use the 10/100BASE-T Ethernet port, use a separate secure subnet for this
connection. Remote connection capability is not enabled by default. If you use SSH
or Telnet to administer the system, you must set the connection type to SSH or
Telnet, using the
connection. Remote connection capability is not enabled by default. If you use SSH
or Telnet to administer the system, you must set the connection type to SSH or
Telnet, using the
setupnetwork
command.
1. At the LOM prompt, type
setupnetwork.
2. Answer the questions in the script.
Note –
If you press the Return key after each question, the current value will not be
changed.
See the Sun Fire Entry-Level Midrange System Controller Command Reference Manual,
819-1268 for full details of the
819-1268 for full details of the
setupnetwork
command.
shows
an example of the
setupnetwork
command.
lom>password
Enter new password:
Enter new password again:
lom>
lom>setupnetwork