Sun Microsystems 10000 用户手册
6
Sun Enterprise 10000 DR Configuration Guide • May 2002
Overview of DR Configuration Tasks
This section identifies the various configuration tasks that you must complete before
running DR operations on Solaris 9 domains (which support only DR model 3.0).
Note that it may not be necessary to perform all the tasks described in this section,
depending on the types of devices on your system boards and the type of DR
operation to be performed.
running DR operations on Solaris 9 domains (which support only DR model 3.0).
Note that it may not be necessary to perform all the tasks described in this section,
depending on the types of devices on your system boards and the type of DR
operation to be performed.
After you configure DR or whenever you make changes to the DR configuration,
you must reboot your domain. If you want to minimize the number of domain
reboots, determine which configuration tasks are applicable to your DR environment
and then perform the appropriate set of configuration tasks before rebooting your
domain.
you must reboot your domain. If you want to minimize the number of domain
reboots, determine which configuration tasks are applicable to your DR environment
and then perform the appropriate set of configuration tasks before rebooting your
domain.
1. If you intend to perform DR detach operations, enable the kernel cage, as
explained in “To Enable the Kernel Cage” on page 17.
2. For devices, do the following:
■
If you set network configuration parameters manually, make these settings
permanent as described in “To Set Permanent Driver Parameters for Network
Drivers” on page 17.
permanent as described in “To Set Permanent Driver Parameters for Network
Drivers” on page 17.
■
If you have
soc
and
pln
devices, enable device suspension, as described in
■
If you have suspend-unsafe devices, specify those devices in the unsafe driver
list, which blocks a quiesce from starting.
list, which blocks a quiesce from starting.
For details, see “To Specify an Unsafe Driver List” on page 18.
■
If you have tape devices that are not supported by Sun Microsystems, make
those devices detach-safe.
those devices detach-safe.
For details, see “To Make an Unsupported Tape Device Detach-Safe” on page
19.
19.
3. If you want to use multipathing, configure your domain for multipathing and run
the appropriate multipathing software on the domain.
4. Reboot the domain to process the configuration changes.
Note –
You must reboot the domain after any changes to the DR configuration. If
you want to minimize the number of reboots, you may want to perform various
configuration tasks then reboot the domain.
configuration tasks then reboot the domain.
5. After the reboot completes successfully, review the
/var/adm/messages
file for
messages that verify the DR configuration changes.