Lenovo 1105 用户手册
Chapter 2. Server setup road map
This chapter provides a general road map to guide you through setting up your server.
The server setup procedure varies depending on the configuration of the server when it was delivered. In
some cases, the server is fully configured and you just need to connect the server to the network and an
electrical outlet, and then you can turn on the server. In other cases, the server needs to have hardware
features installed, requires hardware and firmware configuration, and requires the operating system to
be installed.
some cases, the server is fully configured and you just need to connect the server to the network and an
electrical outlet, and then you can turn on the server. In other cases, the server needs to have hardware
features installed, requires hardware and firmware configuration, and requires the operating system to
be installed.
Table 1. Server setup road map
Task
Where to find the information
Unpack
Install hardware
Connect the Ethernet cable
and power cord
and power cord
Turn on the server to verify
operation
operation
Review the BIOS settings
and customize as needed
and customize as needed
Configure RAID
Check for firmware updates
Install the operating system
and basic drivers
and basic drivers
Install any additional drivers
needed for added features
needed for added features
Refer to the instructions that came with the hardware option.
Configure Ethernet settings
in the operating system
in the operating system
See the operating system help. This step is not required if the operating system was
installed using the ThinkServer EasyStartup program.
installed using the ThinkServer EasyStartup program.
Install applications
Refer to the documentation that comes with the applications that you want to install.
© Copyright Lenovo 2011
3