HP (Hewlett-Packard) ML100 用户手册
Troubleshooting 74
o
Connection of the data cable, but not the power cable, of a new device
4.
Be sure no memory, I/O, or interrupt conflicts exist.
5.
) exist.
6.
Be sure all cables are connected to the correct locations and are the correct lengths. For more
information, refer to the server documentation.
information, refer to the server documentation.
7.
Be sure other components were not unseated accidentally during the installation of the new hardware
component.
component.
8.
Be sure all necessary software updates, such as device drivers, ROM updates, and patches, are
installed and current. For example, if you are using a Smart Array controller, you need the latest Smart
Array Controller device driver.
Array Controller device driver.
9.
Be sure all device drivers are the correct ones for the hardware. Uninstall any incorrect drivers before
installing the correct drivers.
installing the correct drivers.
10.
Press the F10 key to run the BIOS Setup Utility after boards or other options are installed or replaced to
be sure all system components recognize the changes. If you do not run the utility, you may receive a
be sure all system components recognize the changes. If you do not run the utility, you may receive a
POST error message indicating a configuration error. After you check the settings in the BIOS setup
menu, press the F10 key to save and exit the utility, and then restart the server.
11.
Be sure all switch settings are set correctly. For additional information about required switch settings,
refer to the labels located on the inside of the server access panel or the server documentation.
refer to the labels located on the inside of the server access panel or the server documentation.
12.
Be sure all boards are properly installed in the server.
13.
) to see if it recognizes and tests the device.
14.
Uninstall the new hardware.
Unknown problem
Action:
1.
Disconnect power to the server.
2.
Following the guidelines and cautionary information in the server documentation, strip the server to its
most basic configuration by removing every card or device that is not necessary to start the server. Keep
the monitor connected to view the server startup process.
the monitor connected to view the server startup process.
3.
Reconnect power, and then power the system on.
o
)."
CAUTION:
Only authorized technicians trained by HP should attempt to remove the system
board. If you believe the system board requires replacement, contact HP Technical Support ("
" on page
) before proceeding.
o
If the system fails in this minimum configuration, one of the primary components has failed. If you
have already verified that the processor, PPM, power supply, and memory are working before
have already verified that the processor, PPM, power supply, and memory are working before
getting to this point, replace the system board. If not, be sure each of those components is working.
o
If the system boots and video is working, add each component back to the server one at a time,
restarting the server after each component is added to determine if that component is the cause of
restarting the server after each component is added to determine if that component is the cause of
the problem. When adding each component back to the server, be sure to disconnect power to the
server and follow the guidelines and cautionary information in the server documentation.
server and follow the guidelines and cautionary information in the server documentation.