Fujitsu RX900 S1 用户手册
RX900 S1
Maintenance Manual
277
Baseboard
14.6.1 Required tools
●
Starting and completing the task:
–
key for the rack doors (if applicable)
–
Phillips Ph2 screw driver
●
Replacing the baseboard:
–
Phillips Ph0 screw driver
–
Phillips Ph1 screw driver
–
Phillips Ph2 screw driver
14.6.2 Starting the task
Ê
Perform the following procedures:
1.
2.
3.
4.
5.
6. Remove all PSUs, see
7. Remove all CPUMEMRs, see
I
Before removing the CPUMEMRs, take a note on the installation
slot number for each CPUMEMR. Make sure that you reinstall the
CPUMEMR in the slot it was located before the replacement.
slot number for each CPUMEMR. Make sure that you reinstall the
CPUMEMR in the slot it was located before the replacement.
8. Remove all expansion cards and dummy modules in PCIe slots #8 to
#17, see
I
Before removing the expansion cards, take a note on the
installation slot number for each card. Make sure that you reinstall
the card in the slot it was located before the replacement.
installation slot number for each card. Make sure that you reinstall
the card in the slot it was located before the replacement.