Fujitsu BX600 S3 用户手册
BX600 S3
Operating Manual
75
Server Blades
Adding a Server Blade to the System
Figure 30: Removing a server blade dummy module
Ê
Release the locking mechanism of the ejecting handles by pressing the
touch points on the inside of both handles (1) simultaneously. The ejecting
handles of the dummy module will be disengaged.
touch points on the inside of both handles (1) simultaneously. The ejecting
handles of the dummy module will be disengaged.
Ê
Swing up the upper handle and swing down the lower handle simultaneously
(2) until the locking mechanism of the dummy module disengages and the
dummy module ejects.
(2) until the locking mechanism of the dummy module disengages and the
dummy module ejects.
Ê
Remove the dummy module completely from the slot (3).
V
CAUTION!
Keep the dummy module for future use. If the server blade is removed
and not replaced with a new server blade, then the dummy module must
be reinstalled for cooling, to comply with the applicable EMC regulations
(regulations on electromagnetic compatibility) and for fire protection.
and not replaced with a new server blade, then the dummy module must
be reinstalled for cooling, to comply with the applicable EMC regulations
(regulations on electromagnetic compatibility) and for fire protection.
Installation is the same as for the server blade (see
).
!