Polycom 1725-36032-001 用户手册
Configuring the SpectraLink 8000 SVP Server
RTP
traffic is the audio traffic to the PBX. It requires voice quality.
PBX
traffic is not audio to the PBX.
Inter-SVP2
traffic is the information-passing protocol that SVP
Servers use to communicate with each other.
The final DSCP tag of traffic for packets in each of the above Traffic
Classes is governed by the logic below when SVP is used in an SRP
environment:
Classes is governed by the logic below when SVP is used in an SRP
environment:
•
If in-call and
WT (In call)
value is not
Default
then the configured
value is used. Valid range is 0-63.
•
If not in-call and
WT (Standby)
value is not
Default
then the
configured value is used. Valid range is 0-63.
• Default
means “shall not change value of DSCP tag”, in other
words the received DSCP value (from the Gateway) is passed
transparently.
transparently.
Reset System
If this option is selected, you will be prompted to reset the SVP Server
upon exiting this screen.
upon exiting this screen.
The SVP Server should be reset at the end of any maintenance
procedure that requires a reset either via
procedure that requires a reset either via
Maintenance Lock
or
manually via
Reset System.
Note that resetting the SVP Server will terminate any calls in
progress.
progress.
Change Password
If desired, the password to access the SVP Server may be changed.
A password must meet the following requirements:
A password must meet the following requirements:
•
It must be more than four characters, but cannot exceed 16
characters.
characters.
•
The first character must be a letter.
•
Numbers or letters are allowed.
•
No dashes, spaces, or punctuation marks, etc. are allowed.
PN: 1725-36032-001_F.doc
27