ZyXEL Communications nsa325 业主指南

 Chapter 1 Getting to Know Your NSA

Media Server User’s Guide

Before you can start using your NSA210, you have to install the firmware on the hard disk. Use the 
NAS Starter Utility to do this. See 

 for more information on the NAS Starter 

Utility.

Figure 2   NSA210 Hard Disk Partition 

Use the COPY/SYNC button on the front panel to copy or synchronize files between a connected 
USB device and the NSA. See 

 for more details on how to configure the 

copy/sync settings.

Use the RESET button on the rear panel to restore the NSA’s default settings.

Figure 3   The RESET Button

• Press the RESET button until you hear one beep (after about two seconds), then release it. You 

will hear one more beep after you release the button.
This resets the NSA’s IP address and password to the default values.

• Press the RESET button until you hear two beeps. After the second beep, continue pressing the 

button for five more seconds, then release it. You will hear three quick beeps after you release 
the button.
This resets the NSA to the factory default configuration. All settings you have configured on the 
NSA, including IP address, password, user accounts, groups, and so on will be reset to the 
factory defaults.
The reset process does NOT affect the volume settings, nor data stored on the NSA.

You should periodically back up your configuration file to your computer (see 

 for details about managing the NSA’s configuration file). You could then restore your 

configuration in the event that you or someone else reset the NSA to the factory defaults.

Your NSA210’s
firmware is 
installed in the
hard disk.