Toshiba PT930 用户手册
6-18
User's Manual
P
OWER
AND
P
OWER
-U
P
M
ODES
❑
Create or invalidate a supervisor password token
NOTE: This function in the Supervisor password utility lets you
invalidate only supervisor tokens or all tokens, including user and
supervisor tokens.
invalidate only supervisor tokens or all tokens, including user and
supervisor tokens.
❑
Specify restrictions for general users.
Starting the computer by password
If you registered a password, there are two ways to start the computer:
❑
Insert a password token before you turn on the computer. The computer will
start normally, without displaying a password prompt.
start normally, without displaying a password prompt.
❑
Enter the password manually.
NOTE: The password is necessary only if the computer was shut down in
boot mode. It is not needed in Hibernation or Standby mode.
boot mode. It is not needed in Hibernation or Standby mode.
To enter a password manually, follow these steps:
message will appear in the LCD:
Password=
2.
Enter the Password.
3. Press Enter.
NOTE: If you enter the password incorrectly three times in a row, the
computer shuts off. In this case, you must turn the computer back on to
retry password entry.
computer shuts off. In this case, you must turn the computer back on to
retry password entry.
Power-up modes
The computer has the following power-up modes:
❑
Boot: Computer shuts down without saving data. Always save your work
before you turn the computer off in boot mode.
before you turn the computer off in boot mode.
❑
Hibernation: Data in memory is saved to the hard disk.
❑
Standby: Data is maintained in the computer’s main memory.