Toshiba Satellite R10 用户手册
3 Tests and Diagnostics
3.10 Floppy Disk Test
Satellite R10 Maintenance Manual (960-509)
3-23
3.10 Floppy Disk Test
CAUTION: Before running the floppy disk test, prepare a formatted work disk. Remove
the Diagnostics Disk and insert the work disk into the FDD. The contents of
the floppy disk will be erased.
the floppy disk will be erased.
To execute the Floppy Disk Test, select 5 from the DIAGNOSTIC TEST MENU, press Enter
and follow the directions displayed on the screen. After selecting the Floppy Disk Test from the
DIAGNOSTIC TEST MENU, messages to execute the test drive number, media type and test
start truck will be displayed successively. Answer each question with an appropriate response to
execute the test.
and follow the directions displayed on the screen. After selecting the Floppy Disk Test from the
DIAGNOSTIC TEST MENU, messages to execute the test drive number, media type and test
start truck will be displayed successively. Answer each question with an appropriate response to
execute the test.
1. The following message will appear. Select the media mode and start track to be tested, then
press Enter.
Test start track (Enter:0/dd:00-79) ?
2. The Floppy Disk test contains five subtests that test the FDD.
The floppy disk test menu will appear after you select FDD test parameters.
FLOPPY DISK XXXXXXX
XXX DIAGNOSTIC TEST VX.XX
[Ctrl]+[Break] : test end
[Ctrl]+[C]
[Ctrl]+[Break] : test end
[Ctrl]+[C]
: key stop
SUB-TEST
: XX
PASS COUNT
: XXXXX
ERROR COUNT
: XXXXX
WRITE DATA
: XX
READ DATA
: XX
ADDRESS
: XXXXXX
STATUS
: XXX
SUB-TEST MENU
:
01 - Sequential read
02 - Sequential read/write
03 - Random address/data
04 - Write specified address
05 - Read specified address
99 - Exit to DIAGNOSTIC TEST MENU
02 - Sequential read/write
03 - Random address/data
04 - Write specified address
05 - Read specified address
99 - Exit to DIAGNOSTIC TEST MENU